JBR Mud Flap Feedback

[Oni]

@jbarone;

Finally installed my mud flaps I've been sitting on for a while. During the install I found a few issues with the directions that I wanted to flag in case it helps improve them. Part of it may be differences with different years.

Fronts
In step 2 - you call out 5 fasteners with 6 arrows shown. And there was 1 higher on the outer side not shown. Not a big deal, just pointing it out.

Rears
Step 2 - may be worth calling out right and left fender liners are different and there is a plastic washer hiding behind the upper liner. No upper liner on left side

Step 5 and 6 - on my left fender liner, the bumper had "slots" behind the holes you have drilled in the fender liner. The slots are too small to fit the bolts through, so to make mine fit, after I reinstalled the fender liner, I needed to bust out the dremel to open the slot up to the same size as the .25" bolt hole.

Of note, I used the dremel in step 3 on the rears instead and it went super fast.

The flaps look great now that I'm done, just trying to help others who may not be so handy.

Thanks

Edit - added photos

ImageUploadedByTapatalk1439431571.865837.jpgImageUploadedByTapatalk1439431583.605106.jpgImageUploadedByTapatalk1439431594.017346.jpg
ImageUploadedByTapatalk1439431708.915473.jpg

Sent from my iPad using Tapatalk HD

[Raider]

Guessing you did not contact them before posting, amiright?

[Oni]

Originally Posted by Raider Guessing you did not contact them before posting, amiright?

No I did not. I figured it out fine without their help and I'm not complaining at all. Just posting to help them/the community with suggestions and comments. I used the latest directions off their website. So I know it doesn't cover the bumper "slot" issue I ran into. No intent to flame them by any means.


Sent from my iPad using Tapatalk HD

[JBR]

Those are some old school flaps you have there. We haven't had that style for well over a year. They look great!!!

Thanks for the heads up and we'll be sure to update the instructions with your recommendations. We need to update them for the new flaps we make now anyway.

Thanks again!

[Oni]

Originally Posted by jbarone Those are some old school flaps you have there. We haven't had that style for well over a year. They look great!!! Thanks for the heads up and we'll be sure to update the instructions with your recommendations. We need to update them for the new flaps we make now anyway. Thanks again!

Lol, ordered them in Nov 2012. Been lazy with them a while.

[volcomcinematic]

Well this made me chuckle...